LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Manual HVAC Systems - Except Coupe >> Adjustments >> Calibration Test - HVAC Door Motors

Calibration Test - HVAC Door Motors

  1. Turn ignition switch to ON position. Using scan tool, erase BCM DTCs. Cycle ignition switch off, then on. Start engine and allow to idle. Using scan tool, select MISCELLANEOUS, then actuate CALIBRATE HVAC DOOR MOTORS. Follow scan tool screen prompts until completion message is displayed.
  2. After calibration is complete, read, record and erase DTCs. Cycle ignition switch off, then on. Using scan tool, check for HVAC system related DTC/fault messages in BCM. If no HVAC system DTC/fault messages exist, repair is complete. If HVAC system DTC/fault messages are present, diagnose and repair as necessary. See HVAC DIAGNOSTIC TEST DIRECTORY  table under SELF-DIAGNOSTICS.
scientia non olet · About LEMON Manuals