LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Lubrication >> Diagnosis And Testing >> Diagnosis And Testing - Checking Engine Oil Pressure

Diagnosis And Testing - Checking Engine Oil Pressure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil pressure switch. (Refer to ENGINE/LUBRICATION/OIL PRESSURE SENSOR/SWITCH - REMOVAL) 
  2. Install oil pressure test gauge assembly, Special Tools C-3292 with 8406 adaptor.
  3. Start engine and monitor gauge readings.
    CAUTION: If oil pressure is 0 at idle, Do Not Run engine at 3000 RPM
  4. Oil Pressure (engine at operating temperature): Curb Idle   34.5 kPa (5 psi) minimum 3000 RPM   300-724 kPa (45-105 psi).
  5. If oil pressure is 0 at idle. Shut off engine, check for pressure relief valve stuck open or a clogged oil pickup screen.
  6. Install oil pressure switch after testing is completed. (Refer to ENGINE/LUBRICATION/OIL PRESSURE SENSOR/SWITCH - INSTALLATION) 
scientia non olet · About LEMON Manuals