LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Oil Pressure Switch >> Installation

Oil Pressure Switch: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply Mopar® Thread Sealant to the switch threads.
  2. Install oil pressure switch.
  3. Connect electrical connector.
  4. Install oil pressure switch heat shield.
  5. Lower vehicle.
  6. Start engine and check for leaks.
  7. Check engine oil level and adjust as necessary.
scientia non olet · About LEMON Manuals