LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Oil Pressure Switch >> Removal

Oil Pressure Switch: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle on hoist.
  2. Remove heat shield that covers oil pressure switch.
  3. Disconnect oil pressure switch electrical connector.
  4. Position an oil collecting container under switch location.
  5. Remove switch by unscrewing from the engine block.
scientia non olet · About LEMON Manuals