LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> Test 9A: Orc, Driver Squib 1 Circuit Open (Active Code)

Test 9A: Orc, Driver Squib 1 Circuit Open (Active Code)

NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect SRS Load Tool (8310) Brown cable and appropriate jumper to clockspring side of clockspring-to-air bag module connector. Connect DRB to DLC. Turn ignition switch to ON position. Connect negative battery cable. On DRB display, read active air bag DTCs. If DRB displays DRIVER SQUIB 1 CIRCUIT OPEN, go to next step. If DRB does not display DRIVER SQUIB 1 CIRCUIT OPEN, replace driver-side air bag module.
  2. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access and disconnect clockspring lower connector. See CLOCKSPRING  under REMOVAL & INSTALLATION. Connect SRS Load Tool (8310) Black cable and appropriate jumper to harness side of clockspring lower connector. Turn ignition switch to ON position. Connect negative battery cable. On DRB display, read active air bag DTCs. If DRB displays DRIVER SQUIB 1 CIRCUIT OPEN, go to next step. If DRB does not display DRIVER SQUIB 1 CIRCUIT OPEN, replace clockspring.
  3. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access and disconnect ORC connector. See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION. Connect SRS Load Tool (8310) ORC adapter to harness side of ORC connector. Measure resistance of Black-Light Blue wire between ORC adapter and harness side of clockspring lower connector. See WIRING DIAGRAMS  . If resistance is less than 5 ohms, go to next step. If resistance is more than 5 ohms, repair open or high resistance in Black-Light Blue wire.
  4. Measure resistance of Dark Green-Light Blue wire between ORC adapter and harness side of clockspring lower connector. If resistance is less than 5 ohms and no other malfunctions are detected, replace ORC. If resistance is more than 5 ohms, repair open or high resistance in Dark Green-Light Blue wire.
scientia non olet · About LEMON Manuals