Installation Procedure
{If equipped} Install the ignition and start switch:
- Ignition and Start Switch (1) - Install
- Secure the retaining tabs.
Connect the electrical connector.
- Instrument Panel Center Trim Plate Applique (1) - Install
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Trim Plate Applique Bolt (1) - Install and tighten [4x] - Fastener Specifications
Connect the electrical connector.
- Heater and Air Conditioning User Interface Control (2) - Install
- Heater and Air Conditioning User Interface Control Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Center Trim Plate Applique (1) - Install
Instrument Panel Trim Plate Applique - Left Side (2) - Install
- Instrument Panel Trim Plate Applique Bolt (1) - Install and tighten - Fastener Specifications
Secure the instrument panel steering column upper trim cover (1) to the instrument panel steering column lower trim cover in the opposite direction of the arrow.
Connect the electrical connectors.
- Driver Information Display (1) - Install
Driver Information Display Bolt (1) - Install and tighten [5x] - Fastener Specifications
Instrument Panel Bolt Cover - Left Side (1) - Install
Instrument Panel Bolt Cover - Right Side (1) - Install
Instrument Panel Instrument Cluster Hood (2) - Install
- Instrument Panel Trim Plate Strap Bolt (1) - Install and tighten [4x] - Fastener Specifications
Instrument Panel Cluster Trim Plate (1) - Install
Connect the electrical connector.
- Instrument Panel Switch Trim Plate (1) - Install
Instrument Panel Switch Trim Plate Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Knee Bolster (1) - Install
Instrument Panel Knee Bolster Bolt (1) - Install and tighten [3x] - Fastener Specifications
Hood Primary Latch Release Cable Handle (1) @ Instrument Panel Knee Bolster - Install
Instrument Panel Outer Trim Cover - Left Side (1) - Install