LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 44 (Automatic Transmission - 8L45 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Reaction Carrier Assembly, Output Carrier, and Output Shaft Installation >> Special Tools

Special Tools

WARNING: This page is about a different variant/trim than selected.

Equivalent regional tools: Special Tools

  1. GM3977945Courtesy of GENERAL MOTORS COMPANY

    Output Carrier Thrust Bearing (1) - Install

    2. NOTE:

    The output shaft seal is only present on All Wheel Drive (AWD) models.

  2. Output Shaft Seal - O-Ring (2) - Install NEW
  3. Output Shaft (3) - Install
  4. Output Carrier Thrust Bearing (4) - Install
  5. Output Sun Gear (5) - Install
  6. Output Carrier (6) - Install
    7. NOTE:

    Ensure the park pawl is not engaged.

  7. Reaction Carrier (7) - Install
  8. Using DT-50921  Output Carrier/Shaft Lifting Tool installed through component, slowly lower into case.
scientia non olet · About LEMON Manuals