Special Tools
WARNING: This page is about a different variant/trim than selected.
DT-52081 Clearance Gage Plate
Equivalent regional tools: Special Tools
Using DT-52081 Clearance Gage Plate (1), set up the measurement as shown.
- Reaction Sun Gear Thrust Bearing (2) - Measure
- Measure from the top of the Reaction Sun Gear Thrust Bearing (2) to the top of the DT-52081 Clearance Gage Plate (1) as shown and record the measurement.
- Repeat the measurement 180 degrees from the measurement in step 3.
- Find the average of these two measurements from step 3 and step 4. Record this as dimension A.
Using DT-52081 Clearance Gage Plate (1), set up the measurement as shown.
- Stator Shaft Support (2) - Measure
- Measure from the case mating surface to the top of the DT-52081 Clearance Gage Plate (1) as shown and record the measurement.
- Repeat the measurement 180 degrees from the measurement in step 8.
- Find the average of these two measurements from step 8 and step 9. Record this as dimension B.
- Subtract dimension B from dimension A to determine the correct Transmission Case Washer. Transmission Case Washer Specifications , or Transmission Case Washer Specifications (10L60)