Special Tools
WARNING: This page is about a different variant/trim than selected.
DT-8001 Dial Indicator
Equivalent regional tools: Special Tools
Using all of the clutch plates, set up the measurement as shown using DT-8001 Dial Indicator (1).
- 4-5-6-7-8-9-10-Reverse Clutch Backing Plate Retaining Ring (2) -Selective - Measure
- Zero out the dial indicator, then lift the clutch plate stack upwards and record the measurement.
- Repeat the measurement every 120 degrees from the measurement in step 3, completing 3 measurements.
- Find the average of these three measurements from step 3 and step 4. Record this as the clutch travel. Use this number to find the correct clutch backing plate. Clutch Backing Plate Retaining Ring Specifications , or Clutch Backing Plate Retaining Ring Specifications (10L60)