Engine Support Fixture

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Engine Support Fixture Assembly Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Air Cleaner Assembly Replacement Air Cleaner Outlet Duct Replacement Intake Manifold Cover Replacement Special Tools EN-36857 Engine Lift Bracket EN-51007-1 Main Support Beam EN-51007-3 Radiator Support Beam EN-51007-4 Clamp EN-51007-5 Support Leg, Front EN-51007-6 Hook EN-51007-7 Support Leg, Side Equivalent regional tools: Special Tools .
1	EN-36857 Engine Lift Bracket Procedure NOTE: The engine support fixture and lift brackets can be repositioned to either lift bracket to lift in desired lift points. If engine lift brackets are not present, install EN-36857 engine lift brackets as needed.
2	EN-51007-7 Support Leg, Side Procedure NOTE: Ensure that the engine support fixture only contacts the frame in the area indicated by arrows. Do not install on top of fender lip. Install the EN-51007-7 Support Leg, Side to frame as shown.
3	EN-51007-4 Clamp
4	EN-51007-1 Main Support Beam
5	Z EN-51007-3 Radiator Support Beam
6	EN-51007-5 Support Leg, Front
7	EN-51007-6 Hook