Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Equivalent regional tools: Special Tools
- Drain the cooling system. Cooling System Draining and Filling (Static LCV, LGX) , or Cooling System Draining and Filling (GE 47716 LCV, LGX)
- Drain the engine oil. Engine Oil and Oil Filter Replacement
Intake Manifold (3) - Remove - Intake Manifold Replacement
- Exhaust Manifold - Remove - Exhaust Manifold Replacement (LCV)
Engine Front Cover (1) - Remove - Engine Front Cover Replacement
- Remove the timing chain and tensioner. Camshaft Timing Chain and Tensioner Replacement
- Remove the intake and exhaust camshaft, bearing cap, and lash adjusters. Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Removal
- Fuel Pump - Remove - Fuel Pump Replacement
- Disconnect the intake camshaft position sensor. Camshaft Position Sensor Replacement - Intake
- Disconnect the exhaust camshaft position sensor. Camshaft Position Sensor Replacement - Exhaust
Water Outlet (1) - Remove - Water Outlet Replacement (LCV)
- Fuel Injection Fuel Rail - Remove - Fuel Injection Fuel Rail Assembly Replacement
Install the J-36857 Engine Lift Bracket (2) and fastener (1) into the engine block.
- Reposition the engine support fixture lift hook from the engine lift bracket (3) to the J-36857 Engine Lift Bracket (2)
Engine Wiring Harness Ground Bolt (1) - Remove
- Engine Wiring Harness (2) @ Cylinder Head - Remove
- Cylinder Head - Remove - Cylinder Head Removal
- Disassemble the cylinder head. Cylinder Head Disassemble
- Clean and inspect the cylinder head. Cylinder Head Cleaning and Inspection
NOTE:
Support the engine as necessary from underneath while repositioning the engine support fixture.