Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Floor Front Air Outlet Duct - Left Side - Remove - Floor Front Air Outlet Duct Replacement - Left Side
- Radiator Surge Tank - Reposition - Radiator Surge Tank Replacement (LCV) , or Radiator Surge Tank Replacement (LGX) , or Radiator Surge Tank Replacement (LSY)
Air Cleaner Outlet Intermediate Duct (1) - Remove - Air Cleaner Outlet Intermediate Duct Replacement
Turbocharger Outlet Duct Connector (1) - Remove - Turbocharger Outlet Duct Connector Replacement
Disconnect the electrical connector. (1)
- Label the brake pipes to ensure they are re-installed in the correct ports of the brake master cylinder.
- Brake Pipe Fitting (2) - Remove [4x]
- Plug the brake master cylinder ports and the brake pipes to stop fluid loss and contamination.
Disconnect the electrical connector. (1)
- Brake Master Cylinder Bracket Nut (2) - Remove
Wiring Harness Clip (1) - Release
- NOTE:
Some components not shown for graphic clarity.
Brake Master Cylinder Bracket Nut (1) - Remove [2x]
- With the aid of an assistant, hold the brake master cylinder away from the dash panel.
Brake Pedal Retainer (1) - Release
- Pull the brake pedal (2) rearward to release.
Insert a long, thin tool through the power brake booster pass-through from the engine compartment to remove the brake pedal retainer (1).
- Brake Pedal Retainer (1) - Remove and DISCARD
Remove the brake master cylinder (1) from the vehicle.
Brake Master Cylinder Bracket Bolt (1) - Remove [2x]
- Brake Master Cylinder Bracket (2) - Remove and DISCARD
- Transfer components as necessary.