Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Install a NEW gasket.
Camshaft Cover Gasket (1) - Install
- NOTE:
Apply approximately a 5 mm (0.2 in) thick bead of camshaft cover sealant on both sides between the cylinder head and the engine front cover. Refer to Adhesives, Fluids, Lubricants, and Sealers .
Apply sealant in the area indicated by arrows
- Camshaft Cover (3) - Install
- Camshaft Cover Bolt (1, 2) - Loosely install
- CAUTION:
Refer to Fastener Caution .
Tighten the camshaft cover bolts in sequence to 15 N.m (11 lb ft).
- Camshaft Position Actuator Solenoid Valve Replacement - Intake - Install
- Camshaft Position Actuator Solenoid Valve Replacement - Exhaust - Install
- Camshaft Position Sensor Replacement - Intake - Install
- Camshaft Position Sensor Replacement - Exhaust - Install
- NOTE:
If the PCV valve has been removed from the valve cover, replace the valve and tube assembly (2).
Install the PCV valve tube fastener (1). Tighten to 10 N.m (89 lb in)
- Install the engine oil level indicator.
Wiring Harness Connector (2) - ConnectConnect [2x]
- Wiring Harness Retainer (1) - Connect
- Turbocharger Coolant Return Pipe Replacement (LFV) - Install
- Positive Crankcase Ventilation Tube Replacement (Fresh Air) , or Positive Crankcase Ventilation Tube Replacement (Foul Air) - Install
- Vacuum Pump Assembly Replacement - Install
- Fuel Injector Replacement - Install
NOTE:
Ensure correct location of the two camshaft cover double end fasteners (1)
NOTE:
Reposition the wiring harness.