Camshaft Position Sensor Replacement - Intake

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Intake Manifold Cover Replacement
1	Camshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor Procedure Disconnect the electrical connector. Install a NEW seal if not replacing the sensor.

Callout

Component Name

Preliminary Procedure
Intake Manifold Cover Replacement

Camshaft Position Sensor Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Position Sensor

Procedure

Disconnect the electrical connector.
Install a NEW seal if not replacing the sensor.