Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Before continuing, lubricate the cylinder head bore with clean engine oil. Adhesives, Fluids, Lubricants, and Sealers
- Install the Fuel Pump. Fuel Pump Installation
Fuel Feed Pipe (1) @ Fuel Pump (2) - Connect - Metal Collar Quick Connect Fitting Service
Electrical Connector (1) - Connect
- Ensure ALL fittings are clean and dry prior to assembly.
- Install a NEW fuel feed intermediate pipe. Fuel Feed Intermediate Pipe Replacement
- Inspect for leaks using the following procedure:
- Turn ON the ignition with the engine OFF for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition with the engine OFF.
- Inspect for fuel leaks.
- Plenum Front Panel - Install - Plenum Front Panel Replacement (LTG LGX)
NOTE:
If a fuel leak occurs at the fuel pump or fuel injection fuel rail fittings, the corresponding component will need to be replaced.