Plenum Front Panel Replacement (LTG LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the left side front end sheet metal diagonal brace bolt @ plenum front panel. Front End Sheet Metal Diagonal Brace Replacement - Left Side Remove the right side front end sheet metal diagonal brace bolt @ plenum front panel. Front End Sheet Metal Diagonal Brace Replacement - Right Side Windshield Wiper Transmission Replacement
1	Plenum Front Panel Bolt [5x] CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Plenum Front Panel Nut [8x] Tighten 9 N.m (80 lb in)
3	Plenum Front Panel Procedure Disconnect all electrical connectors. Using an appropriate tool, separate the adhesive bond between the plenum front panel and the body. Clean any remaining adhesive with a 50/50 mixture by volume of isopropyl alcohol and clean drinkable water. Wipe surface dry with a clean lint-free towel. Apply an MS polymer body seam sealer to seal the plenum when installing.