Removal Procedure
WARNING: This page is about a different variant/trim than selected.
NOTE:
High pressure fuel feed pipes are one time use only. ALWAYS install a NEW high pressure fuel feed pipe if the pipe is removed OR the fittings are loosened.
- Relieve the fuel system pressure. Fuel Pressure Relief
- Fuel Injection Fuel Rail Noise Shield - Upper - Remove - Fuel Injection Fuel Rail Noise Shield Replacement
- Engine Rear Noise Shield - Remove - Engine Rear Noise Shield Replacement
- Fuel Feed Intermediate Pipe - Remove and DISCARD - Fuel Feed Intermediate Pipe Replacement
Electrical Connector (1) - Disconnect
Fuel Injection Fuel Rail Fastener (1) - Remove [3x]
- NOTE:
The EN-49248-3 remover hooks MUST be properly seated on the underside of the fuel injection fuel rail. The flat EN-49248-4 remover hooks will NOT work for this application.
Install the EN-49248 remover components (1) and slowly work the fuel injection fuel rail (2) upwards in small, even increments.
- Once the fuel injection fuel rail (2) is free, remove the EN-49248 remover components (1).
- Rebuild ALL of the fuel injectors. Fuel Rail and Injectors Cleaning and Inspection
NOTE:
Whenever ANY fuel injector is removed from the cylinder head or the fuel injection fuel rail, the fuel injector MUST be rebuilt.