Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Position the fuel injection fuel rail assembly into the cylinder head as evenly as possible.
Fig 1: Identifying Fuel Injection Fuel Rail Bolts With Tightening Sequence - Bank 2 (Left Side)
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
The final pass should be performed in the sequence shown in the graphic.

To install the fuel injection fuel rail bolts, perform the following steps:
1. First Pass: Start ALL bolts by hand, but do NOT tighten.
2. Second Pass: Tighten the outer two bolts by hand.
3. Third Pass: Tighten the inner bolt by hand.
4. Final Pass: 25 N.m (18 lb ft)
Fuel Feed Intermediate Pipe - Install NEW - Fuel Feed Intermediate Pipe Replacement
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Connect
Inspect for leaks using the following procedure:
1. Turn ON the ignition with the engine OFF for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition with the engine OFF.
4. Inspect for fuel leaks.
Engine Rear Noise Shield - Install - Engine Rear Noise Shield Replacement
Fuel Injection Fuel Rail Noise Shield - Upper - Install - Fuel Injection Fuel Rail Noise Shield Replacement