LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Turbocharger Oil Feed Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine sight shield. Engine Sight Shield Replacement 
  2. Remove the air cleaner outlet duct. Air Cleaner Outlet Duct Replacement
  3. GM4377185Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Wastegate Actuator Pipe (2) @ Turbocharger (1) - Remove

  4. GM4276269Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Wastegate Actuator Pipe (1) @ Power Brake Booster Inlet Hose Connector Fitting (2) - Remove

  5. GM4377186Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Wastegate Actuator Pipe Bolt (1, 3) - Remove [3x]

  6. Remove the turbocharger wastegate actuator pipe nut (5).
  7. Wiring Harness Clip (4) - Unclip [2x]
  8. Turbocharger Wastegate Actuator Pipe (2) - Remove
  9. GM4377187Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Oil Feed Pipe Bracket Bolt (1) - Remove

  10. Turbocharger Oil Feed Pipe Hollow Screw (2) - Remove
  11. Remove and DISCARD the gasket. (3) [2x]
  12. GM4377188Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Oil Feed Pipe Hollow Screw (2) - Remove

  13. Remove and DISCARD the gasket. (3) [2x]
  14. Turbocharger Oil Feed Pipe (1) - Remove
scientia non olet · About LEMON Manuals