LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Turbocharger Oil Feed Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4377188Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Oil Feed Pipe (1) - Install

  2. Install NEW gaskets. (3) [2x]
  3. Turbocharger Oil Feed Pipe Hollow Screw (2) - Install - Do NOT tighten.
  4. GM4377187Courtesy of GENERAL MOTORS COMPANY

    Install NEW gaskets. (3) [2x]

    5. CAUTION:

    Fastener Caution

  5. Turbocharger Oil Feed Pipe Hollow Screw (2) - Install and tighten 25 N.m (18 lb ft)
  6. GM4377188Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Oil Feed Pipe Hollow Screw (2) - Tighten 25 N.m (18 lb ft)

  7. GM4377187Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Oil Feed Pipe Bracket Bolt (1) - Install and tighten 10 N.m (89 lb in)

  8. GM4377186Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Wastegate Actuator Pipe (2) - Install

  9. Wiring Harness Clip (4) - Install [2x]
  10. Install the turbocharger wastegate actuator pipe nut (5) and tighten to 10 N.m (89 lb in)
  11. Turbocharger Wastegate Actuator Pipe Bolt (1, 3) - Install and tighten [3x] 10 N.m (89 lb in)
  12. GM4276269Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Wastegate Actuator Pipe (1) @ Power Brake Booster Inlet Hose Connector Fitting (2) - Install

  13. GM4377185Courtesy of GENERAL MOTORS COMPANY

    Turbocharger Wastegate Actuator Pipe (2) @ Turbocharger (1) - Install

  14. Install the air cleaner outlet duct. Air Cleaner Outlet Duct Replacement
  15. Install the engine sight shield. Engine Sight Shield Replacement 
scientia non olet · About LEMON Manuals