Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
Remove the throttle body assembly. Refer to Throttle Body Assembly Replacement .
Remove the camshaft housing. Refer to Camshaft Housing Replacement .
Remove the crankshaft pulley. Refer to Crankshaft Pulley Replacement .
Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
Courtesy of GENERAL MOTORS COMPANY

NOTE:
To locate the correct camshaft sprocket bolt (2) check the TDC position.

Check if the bores (1) are aligned.
Raise the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Install the 4 crankshaft pulley bolts (1).
Rotate the crankshaft 360 degrees in direction of arrow. Use a pry bar.
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Cover the timing case with a lint-free cloth.

Remove the camshaft sprocket bolt (2) from the intake camshaft sprocket (1), counterhold with a wrench at the camshaft hexagon.
Raise the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Rotate the crankshaft 360 degrees in direction of arrow. Use a pry bar at the 4 crankshaft pulley bolts (1).
Remove the 4 crankshaft pulley bolts (1).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51140 fixing tool (2).
Install the fixing pin into the engine block bore (1) and tighten the 2 bolts (3).
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Cover the timing case with a lint-free cloth.

Remove the camshaft sprocket bolt (2) from the camshaft sprocket (1), counterhold with a wrench at the camshaft hexagon.
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51188 fixing tool (2) to fix the camshaft sprocket (1).
Install the 2 bolts (3).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Cover the timing case with a lint-free cloth.

Remove the camshaft sprocket bolt (2) from the camshaft sprocket (1), counterhold with a wrench at the camshaft hexagon.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not move the camshaft sprocket onto the EN-51188 fixing tool if the intake camshaft was removed.

Slide the camshaft sprocket (1) over the pin (2) of the EN-51188 fixing tool in arrow direction.
Courtesy of GENERAL MOTORS COMPANY

Remove the 4 camshaft bearing rear cap bolts (1).
Remove the camshaft bearing rear cap (2).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-50509 fixing tool (1) to the exhaust camshaft sprocket (2).
Fig 1: Identifying Exhaust Camshaft Bearing Cap Bolts With Loosening Sequence
Courtesy of GENERAL MOTORS COMPANY

Loosen the 8 exhaust camshaft bearing cap bolts in sequence as shown.
Courtesy of GENERAL MOTORS COMPANY

Remove the 8 exhaust camshaft bearing cap bolts (1).
Remove the 4 exhaust camshaft bearing caps (2) and lay aside in the order as they was removed.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
If the exhaust camshaft are reinstall, do not remove the EN-50509 fixing tool.

Remove the exhaust camshaft (1).