Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to: Fastener Caution

Engine Oil Pressure Switch (1) - Install and tighten 35 N.m (26 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Clip (5) - Install
Connect the electrical connector:
1. Starter (1)
2. Fuel Injection Pump (2)
3. Engine Oil Pressure Switch (3)
Exhaust Front Pipe Replacement (1.6L Diesel LH7) - Install
Front Compartment Insulator Replacement - Install
Lower the vehicle.
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection