Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Check the components of the timing chain system for damage and wear:
- Timing chain guides with plastic attachment
- Timing chain tensioner and timing chain tensioner shoe with plastic attachment
- Timing chain and all timing chain sprockets
- Oil pump sprocket
- Oil pump drive chain tensioner
Remove the 2 bolts (3).
- Remove the EN-51140 fixing tool (2).
- Lower the vehicle.
Remove the EN-51143 fixing tool (1).
- Raise the vehicle.
- Install the crankshaft pulley. Refer to Crankshaft Pulley Replacement .
- Install the camshaft housing. Refer to Camshaft Housing Replacement .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Install the engine sight shield. Refer to Engine Sight Shield Replacement .
NOTE:
Before installation, check the components of the timing chain system for damage and wear.