Intake Camshaft Installation
Special Tools
- EN-50509 Split Intake Camshaft Sprocket Fixing Tool
- EN-51143 Camshaft Sprocket Fixing Tool
For equivalent regional tools, refer to Special Tools .
- Check the components of the timing chain system for damage and wear:
- Timing chain guides with plastic attachment
- Timing chain tensioner and timing chain tensioner shoe with plastic attachment
- Timing chain and all timing chain sprockets
- Oil pump sprocket
- Oil pump drive chain tensioner
- NOTE:
Transmit the front marks (1) on the back of the camshaft sprockets.
Marking the exhaust camshaft sprocket and intake camshaft sprocket with paint marks (2), by transmit the front marks (1).
Coat all bearing surfaces with engine oil.
- Install the intake camshaft (1).
Check the marks (1) of the camshaft sprockets whether they are aligned.
- NOTE:
Note the arrows as marks on the camshaft bearing caps, which shows on the outside of the cylinder head.
Install the intake camshaft bearing caps (2) in the order as they was removed.
- Install the intake camshaft bearing cap bolts (1).
-
Courtesy of GENERAL MOTORS COMPANY
CAUTION:Refer to Fastener Caution .
Tighten the 8 intake camshaft bearing cap bolts in sequence as shown to 10 N.m (89 lb in).
Remove the EN-50509 fixing tool (1) or the transport lock from the exhaust camshaft sprocket (2).
Coat all bearing surfaces with engine oil.
- Install the camshaft bearing rear cap (2).
- Install the 4 camshaft bearing rear cap bolts (1).
-
Courtesy of GENERAL MOTORS COMPANY
Tighten the 4 camshaft rear cap bolts in sequence as shown to 25 N.m (18 lb ft).
Install the EN-51143 fixing tool (1), by carefully turning the hexagon of the camshaft.
Before installing the intake camshaft, check the components of the timing chain system for damage and wear.
Ensure the marks (2) of the camshaft sprocket are aligned.