LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - Off Vehicle >> Crankshaft Front Oil Seal Installation

Crankshaft Front Oil Seal Installation

WARNING: This page is about a different variant/trim than selected.

Special Tools

For equivalent regional tools, refer to Special Tools .

  1. GM3282646Courtesy of GENERAL MOTORS COMPANY

    Install EN-51144-1  installer (2) to crankshaft (1).

  2. GM3282647Courtesy of GENERAL MOTORS COMPANY

    Install the NEW crankshaft front oil seal (2) to EN-51144-1  installer (1).

  3. GM3282648Courtesy of GENERAL MOTORS COMPANY

    Install EN-51144-100  crankshaft seal installer (3) to the EN-51144-1  installer (2).

  4. GM3282650Courtesy of GENERAL MOTORS COMPANY

    Press the crankshaft front oil seal into the correct seat, by tighten the bolt (2) of the EN-51144  installer (1).

  5. Press the crankshaft front oil seal as far purely until the EN-51144  installer is on the stop.
  6. Remove the EN-51144  installer.
scientia non olet · About LEMON Manuals