LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze Premier, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.6L (LH7) Diesel) >> Diagnostic Information and Procedures >> Oil Pressure Diagnosis and Testing >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
  2. Raise the vehicle.
  3. Remove the exhaust front pipe. Exhaust Front Pipe Replacement (1.6L Diesel LH7)
  4. Remove the GE-498-B  Oil Pressure Gauge.
  5. Remove the EN-21867-850  Oil Pressure Gage Adapter.
  6. GM3283902Courtesy of GENERAL MOTORS COMPANY

    Install the engine oil pressure sensor (1) to the engine block and tighten to 35 N.m (26 lb ft).

  7. Connect the electrical connector (2) to the engine oil pressure sensor (1).
  8. Install the exhaust front pipe. Exhaust Front Pipe Replacement (1.6L Diesel LH7)
  9. Close the front compartment insulator service opening. Front Compartment Insulator Replacement
  10. Lower the vehicle.
  11. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
scientia non olet · About LEMON Manuals