LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Trax Premier, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions) >> Repair Instructions >> Fuel Tank Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Transfer the evaporative emission canister. Evaporative Emission Canister Replacement (FWD) Evaporative Emission Canister Replacement (AWD) 
  2. Transfer the fuel tank fuel pump module. Fuel Tank Fuel Pump Module Replacement (FWD) Fuel Tank Fuel Pump Module Replacement (AWD) 
  3. Install the fuel tank to the hydraulic lift.
  4. GM2781362

    With the aid of an assistant, position the fuel tank to the vehicle.

    5. CAUTION:

    Refer to Fastener Caution .

  5. Install both fuel tank straps to the fuel tank (2) and tighten the fasteners to 22 N.m (16 lb ft).
  6. Remove the hydraulic lift from the fuel tank.
  7. Connect the EVAP system hoses. Plastic Collar Quick Connect Fitting Service 
  8. Connect the fuel feed pipe. Plastic Collar Quick Connect Fitting Service 
  9. Connect the fuel tank filler pipe. Fuel Tank Filler Pipe Replacement 
  10. GM2781400

    Connect the fuel tank fuel pump module wiring harness (1) and clip the fuel tank module wiring harness to the chassis.

  11. Install the exhaust. Exhaust Muffler Replacement (2H0)Exhaust Muffler Replacement (LUV)Exhaust Muffler Replacement (LE2)
  12. Install the right rear wheelhouse panel liner. Rear Wheelhouse Liner Replacement
  13. Lower the vehicle.
  14. Return fuel to the tank.
scientia non olet · About LEMON Manuals