Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the throttle body assembly from the engine. Refer to Throttle Body Assembly Replacement Throttle Body Assembly Replacement (LV7) .
Remove the clutch master cylinder reservoir hose from the clutch master cylinder. Refer to Clutch Master Cylinder Reservoir Hose Replacement (Left Hand Drive) Clutch Master Cylinder Reservoir Hose Replacement (Right Hand Drive) .
Courtesy of GENERAL MOTORS COMPANY

Remove the retaining clip (1).
Disconnect the clutch actuator cylinder front pipe (2) from the clutch master cylinder.
Courtesy of GENERAL MOTORS COMPANY

Remove the 2 clutch master cylinder mount nuts (1).
Remove the clutch pedal return spring. Refer to Clutch Pedal Return Spring Replacement (Left Hand Drive) Clutch Pedal Return Spring Replacement (Right Hand Drive) .
Remove the clutch pedal position sensor. Refer to Clutch Pedal Position Sensor Replacement .
Courtesy of GENERAL MOTORS COMPANY

Disconnect the clutch master cylinder push rod from the clutch pedal (3), using the DT-50894 remover (2) along with the DT-6202-B pliers (1).
Remove the clutch master cylinder in the direction of the engine compartment.