LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Interior Trim And Interior Paneling) >> Repair Instructions >> Quarter Lower Rear Trim Panel Replacement

Quarter Lower Rear Trim Panel Replacement

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Quarter Lower Rear Trim Panel
GM4054840Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the rear seat back cushion. Refer to Rear Seat Back Cushion Removal and Installation (Base)Rear Seat Back Cushion Removal and Installation (40 Percent Seat)Rear Seat Back Cushion Removal and Installation (60 Percent Seat) .
  2. Remove the rear side door sill trim plate. Refer to Rear Side Door Sill Garnish Molding Replacement .
  3. Remove the quarter window trim finish panel. Refer to Quarter Window Trim Finish Panel Replacement .
  4. Remove the load floor trim panel. Refer to Load Floor Trim Panel Replacement .
  5. Remove the liftgate sill garnish molding. Refer to Liftgate Sill Garnish Molding Replacement .
1 Quarter Lower Rear Trim Panel Push Pin Clip
2 Quarter Lower Rear Trim Panel Plastic Retainer (Qty: 3)
3 Quarter Lower Rear Trim Panel Clip (Qty: 2)
4 Quarter Lower Rear Trim Panel Assembly

Procedure

  1. Release the rear seat belt anchor bracket from the rear seat.
  2. Use a flat-bladed plastic trim tool to release the quarter lower rear trim panel from the quarter inner panel.
  3. Disconnect the electrical connectors.
scientia non olet · About LEMON Manuals