Installation Procedure
- NOTE:
Install a NEW gasket.
NOTE:Add 14mm bead of sealant part # 12378521 at right and left T-Joint where front cover meets head and at rear of camshaft cover right and left T-Joint where vacuum pump bolts on.
Camshaft Cover Gasket (1) - Install
Camshaft Cover (4) - Install
- Camshaft Cover Bolt (3) - Loosely install [19x]
- Camshaft Cover Washer (2) - Install
- Camshaft Cover Bolt (1) - Loosely install [4x]
-
CAUTION:
Refer to Fastener Caution .
Tighten the bolts in the sequence shown.10 N.m (89 lb in).
- Install the engine coolant air bleed pipe. Refer to Engine Coolant Air Bleed Pipe Replacement (LCV) .
Position the bracket (2) then install the wiring harness bracket fastener (1). Tighten to 10 N.m (89 lb in).
Install the vacuum assembly (1). Refer to Vacuum Pump Replacement .
Install the camshaft position actuator intake (1) solenoid valve. Refer to Camshaft Position Actuator Intake Solenoid Valve Replacement .
- Install the camshaft position actuator exhaust (2) solenoid valve. Refer to Camshaft Position Actuator Exhaust Solenoid Valve Replacement .
Install the ignition coils (1). Refer to Ignition Coil Replacement .
Connect vacuum booster pipe (1).
Install the camshaft cover heat shield (2) and bolts (1). Tighten the bolts to 10 N.m (89 lb in).
- Inspect the oil level indicator O-ring seals (4) and replace if necessary. Install the oil level indicator (3).
- Install the positive crankcase ventilation hose/pipe/tube. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
Ensure the long camshaft cover bolts (1) are installed in the correct positions.