Vacuum Pump Replacement

WARNING: This page is about a different variant/trim than selected.

Callout	Component Name
Preliminary Procedure Remove the intake manifold cover. Intake Manifold Cover Replacement Disconnect the vacuum hose from the vacuum pump. Plastic Collar Quick Connect Fitting Service
1	Vacuum Pump Fastener (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Vacuum Pump Procedure Lubricate the vacuum pump seal with clean engine oil. Adhesives, Fluids, Lubricants, and Sealers Align the vacuum pump drive with the slot in the camshaft. NOTE: Inspect the vacuum pump seal and replace as necessary.
3	Vacuum Pump Gasket Procedure Inspect the vacuum pump gasket and replace as necessary.