LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove Air Cleaner Assembly - Air Cleaner Assembly Replacement
  2. Remove Camshaft Cover - Camshaft Cover Replacement (1st Design Tamper-Proof PCV System) 
  3. Remove Engine Mount - Engine Mount Replacement 
  4. Remove Crankshaft Balancer - Crankshaft Balancer Replacement 
  5. Remove Drive Belt Tensioner - Drive Belt Tensioner Replacement 
    6. Fig 1: Identifying Engine Front Cover Bolts
    GM4650467Courtesy of GENERAL MOTORS COMPANY
  6. Remove Engine Front Cover Bolt (1, 2, 3) and DISCARD
    7. Fig 2: Identifying Front Cover Bolts
    GM4650465Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The engine front cover bolts vary in lengths. Mark the bolts to ensure they are installed in the correct locations.

  7. Remove Engine Front Cover Bolt (1) [2x]
  8. Remove Engine Front Cover Bolt (2) [12x]
  9. Remove Engine Front Cover Bolt (3) [2x]
  10. Remove Engine Front Cover Bolt (4)
  11. Remove Engine Front Cover (5).
  12. If replacing the engine front cover, remove and DISCARD the crankshaft front oil seal (6) using an appropriate tool.
scientia non olet · About LEMON Manuals