LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Equinox L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P0016 - P049D)) >> Diagnostic Information And Procedures >> DTC P0340 Or P0341: Camshaft Position Sensor Circuit/Performance >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC P0641, P0651 is not set.
    • Go to next step: If the DTC is not set 
  3. Engine - Running
  4. Verify DTC P0341 is not set.
    • If the DTC is set 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  6. All OK.
scientia non olet · About LEMON Manuals