LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Front Suspension Strut Yoke - Remove - Front Suspension Strut Yoke Replacement 
  2. Front Wheel Bearing and Hub Assembly - Remove - Front Wheel Bearing and Hub Replacement 
  3. GM2394297

    Loosen the steering knuckle king pin bushing nuts (1) until they are even with the steering knuckle king pin bushing studs or two or three threads of each nut are exposed.

  4. Use a hammer and brass punch to drive both of the steering knuckle king pin bushing studs partially inward to release the knurls from the steering knuckle king pin bushing.
  5. Remove and DISCARD the steering knuckle king pin bushing nuts.
  6. Disconnect the steering knuckle upper ball stud from the steering knuckle. Steering Knuckle Upper Ball Stud Replacement 
  7. GM2394358

    Remove the steering knuckle (1) from the front suspension strut yoke.

scientia non olet · About LEMON Manuals