Removal Procedure
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
- Steering Knuckle - Remove - Steering Knuckle Replacement
- Front Suspension Strut Yoke - Remove - Front Suspension Strut Yoke Replacement
- Front Wheel Bearing and Hub Assembly - Remove - Front Wheel Bearing and Hub Replacement
- Secure the steering knuckle in a vise with the steering knuckle king pin facing up, taking care not to damage any machined surfaces.
Thread the EN-46720 injector remover (1) onto the DT-45124 removal bridge (2).
- The DT-45124 removal bridge has two adjustable width legs. The legs should be adjusted to the narrowest position.
- The DT-45124 removal bridge comes with two pulling bolts. Use the longer pulling bolt.
- Before installing the EN-46720 injector remover into the steering knuckle king pin, ensure the king pin bolt hole threads are clean. The bolt hole threads are M8 x 1.25.
- Thread the EN-46720 injector remover (1) into the steering knuckle king pin (3) and position the legs of the DT-45124 removal bridge (2) on the steering knuckle.
Once the special tools are installed, to remove the steering knuckle king pin from the steering knuckle, use a wrench or socket to hold the pulling bolt (1) while simultaneously using a wrench (2) to turn the pulling nut clockwise.
- Once the steering knuckle king pin (3) is completely removed, the steering knuckle king pin bushing (4) can be removed from the steering knuckle.
NOTE: