LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 5ET50 (MKE)) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Engine Wiring Harness Junction Block - Remove Engine Wiring Harness Junction Block Replacement (With HP4)Engine Wiring Harness Junction Block Replacement (Without HP4)
  2. Engine Wiring Harness Fuse Block Bracket - Remove Engine Wiring Harness Fuse Block Bracket Replacement
  3. Electronic Brake Control Module with Brake Pressure Modulator Valve - Remove Electronic Brake Control Module with Brake Pressure Modulator Valve Replacement
  4. Using a suitable jack, support the transmission.
  5. Prior to removing the mount, mark the mount location using paint pen or a marker for correct positioning during installation.
  6. Transmission bracket bolt (1) - Remove [2x]
    Fig 1: Transmission Mount Bolt
    GM4283617Courtesy of GENERAL MOTORS COMPANY
  7. Remove the transmission bracket (2).
  8. Remove the three wiring harness retainers and reposition the main wiring harness from the left frame rail.
  9. Transmission Mount Bolt (3) Remove [2x]
  10. Transmission Mount Bolt (4) Remove and DISCARD [3x]
  11. Transmission Mount (5) - Remove
scientia non olet · About LEMON Manuals