Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair.
NOTE:
Perform the Control Solenoid Valve Inspection for the following components before replacing the components.
- Manual Shift Shaft and Manual Shift Detent Lever Replacement for B15 Transmission Internal Mode Switch, often referred to as the Automatic Transmission Manual Shift Detent Lever with Shaft Position Switch Assembly, replacement.
- Control Valve Assembly and Transmission Wiring Harness Removal for Automatic Transmission Wiring Harness - Shift Shaft Position Switch replacement.
- Control Module References for T6 Power Inverter Module, often referred to as the Drive Motor Generator Power Inverter Module, replacement, programming and setup.
- Solenoid Valve Characterization Reprogramming when the T6 Power Inverter Module, Valve Body or Q23 Line Pressure Control Solenoid is replaced.
- Perform the Reset Transmission Adapts following all transmission related repairs.