Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify that P0721, P077B-P077D or P215C is not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
Perform the Transmission Fluid Level and Condition Check to verify correct fluid level and condition.
- If the transmission fluid is low or discolored, refer to Transmission Fluid Drain and Fill .
Operate the vehicle within the Conditions for Running the DTC while observing the Clutch 2 Slip Speed parameter. The Clutch 2 Slip Speed parameter should display greater than 30 RPM when the Clutch 2 Status parameter displays Released.
- If the DTC P07A5 is set, go to Component Testing .