LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Control Valve Body Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the control valve body cover (1).
    Fig 1: Control Valve Body Cover
    GM4489058Courtesy of GENERAL MOTORS COMPANY
  2. Hand start the control valve body cover bolts (1, 2).
    Fig 2: Control Valve Body Cover Bolts
    GM4489055Courtesy of GENERAL MOTORS COMPANY
    NOTE: The number (1) bolts are stud bolts.
  3. Install the control valve body cover bolts. Tighten the bolts in sequence to 10 N.m (89 lb in).
    CAUTION: Refer to Fastener Caution .
    NOTE: Install all control valve body cover bolts and stud bolts by hand then torque all bolts in sequence.
  4. Install the body ground cable and wiring harness assembly to the front of transmission.
  5. Connect the transmission fluid cooler outlet pipe (1) to the transmission. Refer to Transmission Fluid Cooler Outlet Pipe Replacement (LFV With MHN)Transmission Fluid Cooler Outlet Pipe Replacement (LKN With MKE) .
    Fig 3: Transmission Fluid Cooler Inlet And Outlet Pipe
    GM4489039Courtesy of GENERAL MOTORS COMPANY
  6. Connect the transmission fluid cooler inlet pipe (2) to the transmission. Refer to Transmission Fluid Cooler Inlet Pipe Replacement (LFV With MHN)Transmission Fluid Cooler Inlet Pipe Replacement (LKN With MKE) .
  7. Connect the control valve body transmission control module electrical connector (1), then clip the wiring harness to the cover.
    Fig 4: Control Valve Body Transmission Control Module Electrical Connector
    GM4489022Courtesy of GENERAL MOTORS COMPANY
  8. Fill the transmission with correct fluid. Refer to Adhesives, Fluids, Lubricants and Sealers
  9. Check transmission fluid level. Refer to Transmission Fluid Level and Condition Check .
  10. Install the transmission control module bracket. Refer to Transmission Control Module Bracket Replacement 
  11. Install the charge air cooler outlet air tube. Refer to Charge Air Cooler Outlet Air Tube Replacement .
  12. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9) .
  13. Check for leaks.
scientia non olet · About LEMON Manuals