LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Ignition Lock Cylinder Replacement (Without BTM)

Ignition Lock Cylinder Replacement (Without BTM)

WARNING: This page is about a different car, the 2015 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition Lock Cylinder
GM2739331Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Without Start/Stop) and Battery Negative Cable Disconnection and Connection (With Start/Stop) .
  2. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  3. Remove the ignition lock cylinder bezel. Refer to Ignition Lock Cylinder Bezel Replacement (Without BTM) .
1 Ignition Lock Cylinder

Procedure

  1. Turn the ignition lock cylinder to the RUN position.
  2. Insert a pick-type tool into the proper hole on the ignition and start switch housing and press the lock tab on the ignition lock cylinder down while turning the cylinder to the START position.
  3. Pull the ignition lock cylinder out of the ignition and start switch housing.
  4. If installing a new ignition lock cylinder then refer to Lock Cylinder Coding - Ignition .
scientia non olet · About LEMON Manuals