LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T30 (MH9) Or 6T40 (MH8) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Control Valve Body Cover Replacement (1.4L LUV) >> Installation Procedure

Installation Procedure

  1. Install the NEW control valve body cover wiring connector hole seal (4).
    Fig 1: View Of Control Valve Body
    GM1999445Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW control valve body cover gasket (3) to the control valve body cover.
  3. Install the control valve body cover (2).
  4. Hand start the 13 control valve body cover bolts (1).
  5. Install the control valve body cover bolts. Tighten the bolts in sequence to 12 N.m (106 lb in).
    Fig 2: Identifying Valve Body Cover Bolt Tightening Sequence
    GM1999447Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    NOTE: Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.
  6. Connect the electrical connector (1) TCM, then clip in the wiring harness to transmission.
    Fig 3: Identifying Control Valve Body Transmission Control Module (TCM) Electrical Connector
    GM1999448Courtesy of GENERAL MOTORS COMPANY
  7. Install the wiring harness starter motor to transmission. Install bolt to retainer on valve body cover. Clip in wiring harness to retainer on valve body cover and range selector cable bracket.
  8. Raise the vehicle.
  9. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  10. Lower the vehicle.
  11. Install the transmission fluid cooler outlet pipe. Use NEW sealing washer. Refer to Transmission Fluid Cooler Outlet Pipe Replacement (1.4L LUV) .
  12. Install the transmission fluid cooler inlet pipe to the transmission. Use NEW sealing washer. Refer to Transmission Fluid Cooler Inlet Pipe Replacement (1.4L LUV) .
  13. Install the radiator inlet hose. Refer to Radiator Inlet Hose Replacement (1.4L LUV) .
  14. Install the charge air cooler outlet air hose. Refer to Charge Air Cooler Outlet Air Hose Replacement (Manual Transmission) and Charge Air Cooler Outlet Air Hose Replacement (Automatic Transmission) .
  15. Install the fluid level drain plug (1) and tighten to 12 N.m (106 lb in)
    Fig 4: Identifying Fluid Level Hole Plug
    GM1998836Courtesy of GENERAL MOTORS COMPANY
  16. Top up transmission fluid and check transmission fluid level. Refer to Transmission Fluid Drain and Fill .
  17. Check for leaks.
  18. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals