Automatic Transmission Flex Plate Installation

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-46792 Flywheel Holder

For equivalent regional tools, refer to Special Tools .

Install the automatic transmission flexplate (2) and loosely install the 6 NEW automatic transmission flexplate bolts (1).

Fig 1: Automatic Transmission Flexplate Bolts
Courtesy of GENERAL MOTORS COMPANY

NOTE: The automatic transmission flexplate only fits in one position.
Install the EN-46792 holder (2) to the automatic transmission flexplate (1) in order to lock the crankshaft.

Fig 2: Automatic Transmission Flexplate
Courtesy of GENERAL MOTORS COMPANY
Tighten the automatic transmission flexplate bolts to 160 N.m (118 lb ft).
CAUTION: Refer to Fastener Caution .