LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LUZ) Diesel) >> Diagnostic Information and Procedures >> Oil Pressure Diagnosis and Testing >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle.
  2. Remove the engine oil cooler outlet hose. Refer to Engine Oil Cooler Outlet Hose Replacement (2.0L Diesel LUZ) .
  3. Remove EN-498-B  gauge.
  4. Install the oil pressure sensor (1) and a NEW oil pressure indicator sensor seal ring.
    Fig 1: Oil Pressure Sensor
    GM2512731Courtesy of GENERAL MOTORS COMPANY
  5. Tighten the oil pressure sensor to 20 N.m (15 lb ft).
    CAUTION: Refer to Fastener Caution .
  6. Install the engine oil cooler outlet hose. Refer to Engine Oil Cooler Outlet Hose Replacement (2.0L Diesel LUZ) .
  7. Lower the vehicle.
  8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals