Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Engine Running.
Verify the parameters listed below do not display Malfunction when commanding the Engine Oil Pressure Control Solenoid Valve to High Pressure and Low Pressure with a scan tool.
- Engine Oil Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
- Engine Oil Pressure Control Solenoid Valve Control Circuit Open Test Status
- Engine Oil Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
- If Malfunction is displayed
  Refer to Circuit/System Testing .
- If Malfunction is not displayed
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If any DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.