Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Using a hydraulic jack stand with the DT 50187 supporter and the CH 51035 adapter , position the rear axle assembly (1) in the vehicle.
- Align the mounting points of the rear axle to the painted outline (1) on the chassis.
- Install the rear axle mounting bolts (1).
- Using the EN-45059
meter , tighten the rear axle mounting bolts (1) to:
- First Pass 160 N.m (118 lb ft)
- Final Pass plus 38 degrees
- Install the rear spring. Rear Spring Replacement
- Install the rear wheel bearing/hub mounting bolts to the rear axle. Rear Wheel Bearing and Hub Replacement (With Drum Brakes) Rear Wheel Bearing and Hub Replacement (With Disc Brakes)
- Install the rear park brake cables.
- Install the exhaust muffler. Exhaust Muffler Replacement (2H0)Exhaust Muffler Replacement (LUV)
- If equipped, install the differential carrier assembly. Differential Carrier Assembly Replacement
- If equipped, install the rear propeller shaft. Two-Piece Propeller Shaft Replacement
- If equipped, install the rear suspension 4 corner leveling system position sensor.
- Install the rear brake lines on the rear axle.
- Bleed the hydraulic brake system. Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure)
- Install the rear tire and wheel assemblies. Tire and Wheel Removal and Installation
CAUTION:
Refer to Fastener Caution .