LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick) .
  2. Install the engine support fixture. Refer to Engine Support Fixture .
  3. Remove the engine mount. Refer to Engine Mount Replacement - Right Side .
    4. Fig 1: Holding Wrench And Drive Belt Tensioner
    GM2191345Courtesy of GENERAL MOTORS COMPANY
  4. Install EN-48488  holding wrench (2) to the drive belt tensioner (1).
    5. Fig 2: Locking Pin
    GM2191140Courtesy of GENERAL MOTORS COMPANY
  5. Move the drive belt tensioner clockwise until the drive belt tensioner can be fixed with EN-955  locking pin (1).
  6. Remove the EN-48488  holding wrench.
    7. Fig 3: Drive Belt
    GM2571360Courtesy of GENERAL MOTORS COMPANY
  7. Remove the drive belt (1).
scientia non olet · About LEMON Manuals