LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Camshaft Intake and Exhaust Sprocket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Timing Chain And Camshaft Sprockets
    GM2191431Courtesy of GENERAL MOTORS COMPANY
  1. Install the camshaft sprockets (2) and timing chain (1) as one unit.
    2. Fig 2: Camshaft Position Exciter Wheels And Camshaft Sprocket Bolts
    GM2191382Courtesy of GENERAL MOTORS COMPANY
  2. Install the camshaft position exciter wheels (1).
  3. Install the NEW camshaft sprocket bolts (2) hand tight only.
  4. Remove the EN-955-A  pin to apply tension to the timing chain .
    5. NOTE:

    Engine must be adjusted to TDC.

  5. Adjust the camshaft timing chain. Refer to Camshaft Timing Chain Adjustment .
    6. Fig 3: Upper Timing Chain Guide And Bolts
    GM2190676Courtesy of GENERAL MOTORS COMPANY
  6. Install the upper timing chain guide (2).
    7. CAUTION:

    Refer to Fastener Caution .

  7. Install the upper timing chain guide bolts (1) and tighten to 8 N.m (71 lb in).
    8. Fig 4: Timing Chain Tensioner Plug
    GM2191145Courtesy of GENERAL MOTORS COMPANY
  8. Install the timing chain tensioner plug (1) and tighten to 50 N.m (37 lb ft).
  9. Install both camshaft position actuator solenoid valves. Refer to Camshaft Position Actuator Solenoid Valve Replacement .
  10. Install the camshaft cover. Refer to Camshaft Cover Replacement .
  11. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  12. Check and correct engine oil level.
scientia non olet · About LEMON Manuals