LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System) >> Diagnostic Information and Procedures >> Rattle, Clunk, Pop or Shudder Noise from the Power Steering System (LUJ, N40)

Rattle, Clunk, Pop or Shudder Noise from the Power Steering System (LUJ, N40)

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
1 Did you review the Power Steering System Description and Operation and perform the necessary inspections? Go to Step 2  Go to Symptoms - Power Steering System 
2 Verify that a rattle, clunk or shudder noise is present.
Is a rattle, clunk or shudder noise present?
Go to Step 3  System OK
3 Inspect the power steering hoses for proper routing and clearance.
Is the routing or clearance of the power steering hoses incorrect?
Go to Step 11  Go to Step 4 
4 Inspect the engine drive belt for cracking or excessive wear. Refer to Drive Belt Falls Off and Excessive Wear Diagnosis .
Is the drive belt cracked or excessively worn?
Go to Step 12  Go to Step 5 
5 Inspect the power steering pump pulley for damage.
Is the power steering pump pulley damaged?
Go to Step 13  Go to Step 6 
6 Inspect the power steering pump and the power steering mounting bracket for the proper installation. Refer to Power Steering Pump Replacement .
Is the power steering pump installation incorrect?
Go to Step 14  Go to Step 7 
7 Inspect the power steering gear for the proper installation. Refer to Steering Gear Replacement (N40) .
Is the power steering gear installation incorrect?
Go to Step 15  Go to Step 8 
8 Inspect for looseness in the inner tie rods or in the outer tie rods. Refer to Steering Linkage Inner Tie Rod Inspection , and to Steering Linkage Outer Tie Rod Inspection .
Are the inner tie rods or the outer tie rods worn?
Go to Step 16  Go to Step 9 
9 Inspect the suspension. Refer to Noise Diagnosis - Front Suspension .
Is the suspension worn?
Go to Step 17  Go to Step 10 
10 Inspect the intermediate shaft.
Is the intermediate shaft worn?
Go to Step 18  Go to Step 3 
11 Adjust or replace the hoses. Refer to the appropriate procedures:
Did you complete the repair?
Go to Step 19  -
12 Replace the drive belt. Refer to Drive Belt Replacement .
Did you complete the repair?
Go to Step 19  -
13 Replace the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .
Did you complete the repair?
Go to Step 19  -
14 Install the power steering pump correctly. Refer to Power Steering Pump Replacement .
Did you complete the repair?
Go to Step 19  -
15 Install the power steering gear correctly. Refer to Steering Gear Replacement (N40) .
Did you complete the repair?
Go to Step 19  -
16 Replace either the worn inner tie rod or the worn outer tie rod. Refer to Steering Linkage Inner Tie Rod Replacement (N40)  or to Steering Linkage Outer Tie Rod Replacement .
Did you complete the repair?
Go to Step 19  -
17 Replace the worn suspension components.
Did you complete the repair?
Go to Step 19  -
18 Replace the intermediate shaft. Refer to Intermediate Steering Shaft Replacement (N40) .
Did you complete the repair?
Go to Step 19  -
19 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3