LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transmission - 6T40 (MH8 MHB) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine coolant fan shroud. Refer to Engine Coolant Fan Shroud Replacement (2H0)Engine Coolant Fan Shroud Replacement (LUJ, LUV) .
  2. Remove the automatic transmission range selector lever. Refer to Automatic Transmission Range Selector Lever Replacement .
  3. Remove the control valve body. Refer to Control Valve Body Replacement .
    4. Fig 1: View Of Manual Shift Detent Lever & Shaft Position Switch Assembly
    GM1998834Courtesy of GENERAL MOTORS COMPANY
  4. Remove the manual shaft detent lever hub pin (1) using a pry bar and pliers.
  5. Remove and DISCARD the manual shift shaft pin (5).
  6. Remove the manual shaft (2).
    7. NOTE:

    Disconnect the actuator rod (3) from the detent lever assembly. Do not remove the actuator rod from the transmission case.

  7. Remove the manual shaft detent (with shift position switch) lever assembly (4).
scientia non olet · About LEMON Manuals