Control Valve Body Replacement

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Control Valve Body

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement . Disconnect the output speed sensor harness at retainer on fluid control valve.
1	Fluid Level Control Valve
2	Fluid Level Control Valve Gasket Procedure DISCARD the Gasket. Use a NEW gasket ONLY.
3	Control Valve Body Bolt M6 x 60 (Qty: 9) CAUTION: Refer to Fastener Caution . NOTE: Tighten in specified sequence. Tighten 11 (97 lb in)
4	Control Valve Body Bolt M6 x 53 (Qty: 2) NOTE: Tighten in specified sequence. Tighten 11 (97 lb in)
5	Control Valve Body Assembly Procedure After repairs, refer to Control Module References for programming and set up procedures. Perform the transmission adaptive values learn. Refer to Transmission Adaptive Values Learn .
6	Control Valve Body Spacer Plate Assembly
7	Manual Shaft Detent Spring Bolt M6 x 16 (Qty: 1) Tighten 12 (106 lb in)
8	Manual Shaft Detent Lever Spring Assembly
9	1-2-3-4 Clutch Fluid Passage Seal NOTE: Discard the seal. It is not reusable.
10	Low/Reverse Clutch Fluid Passage Seal NOTE: Discard the seal. It is not reusable.